|
STMODHARNMX00FASTMotorsports
FASTMotorsports has teamed with GP Motorsports to develop the latest in simple harnessing for any MoTeC project. Its called Modular harnessing and it puts the power of harness design in your hands. With a Modular DIY harness, the main trunk of the harness is built at the factory. It includes every sensor and output offered for your ECU. All wiring is completed up to the firewall connector. From the firewall forward what your harness contains is up to you. Modular pre built looms can be ordered based on the sensor you want to use. They already have the sensor end completed and contain a label for that particular sensor. All you have to do, is cut to length and terminate using the supplied terminals and crimper. Then simply slide the pins into the correct slot on the harness and you are ready to run. DIY harnesses never were this easy nor did they come out this professional! The only requirement on your end are wire cutters and a nice wire stipping tool. But - if you dont have that - you can order them from us as well.----- MX00 Series Features: MX00 Connector Terminated 48" to firewall----- CAN Communications Connector - 36"----- CAN Expansion Connector - 36"----- Baro Sensor Lead - 14"----- Ignition Power Lead - 72"----- Battery Power Lead - 72"----- Ground Lead - 72"----- Aux 3 Tach Lead - 36"----- Aux 7 Cooling Fan Relay Trigger - 36"----- Aux 8 Fuel Pump Relay Trigger - 36"----- Digital 3,4 for Wheelspeed or Sw Input - 36"----- AT 5,6 for MAP Sw or Temp Measurement - 36"----- AV 7,8 for Voltage Measurement - 36"-----
E-mail a friend about this item. |
|
|
