|
JoCelleRator
|
|
Automatic Water Tank & Circuit (vertical)
(DIY) U-Solder Automatic Water Level Circuit & Vericle Tank with pump motor. Works inside your cell with 3 probes, high and low level & ground. Comes with a 12v. water pump & tank.
PRICE: $70.00
|
|
DSF Fuel Saver HHO Edition
The NEW! Volo DSF Fuel Saver HHO Edition Circuit - FS2 (released 8/09)
These LOW PRICE DSF Circuits works by an exclusive process of "Dynamic Soft-Flashing" the ECU. The new FS2 was specially designed for the addition of hydroxy gas generators.
New introductory sale price - $89.95! Check availability for your Make, Model, Year car or truck.
Each "DSF Fuel Saver" comes programmed with a highly tuned map and a set of EPROM addresses that directly affect fuel delivery and timing, based on readings from the MAP/MAF, IAT, and O2 sensors. When the ECU attempts to read the specific EPROM address, the DSF circuit patches the factory value with one from its tuned map. Easy to install.
Your Satisfaction is Guaranteed!
PRICE: $89.95
|
|
Hydroxy Air Dyer
"Hydroxy Air Dyer" 5" filter housing, used after your bubbler to your air intake. Used to make your hydroxy gas dryer ( more combustionable) also one more step in protecting your engine from electrolyte vapors. Comes with filter and 2 barb fittings. (Now in stock! 1/14/09)
PRICE: $25.00
|
|
Jo-CelleRator
The "Jo Cell eRator" Hydrogen Generator is here! (pronounced : Joe Cell-er Rator ) A configuration of a Down under design : Joe Cell, but this one makes Egas, and not directed as a 100% orgone energy device. It puts out approx. 2-3 liters per minute at 10 - 30 amps, once conditioned. (weks of use) Comes with just parts and you assemble. Add 2 together for larger engines, to get 4-6 liters per minute!
PRICE: $350.00
|
|
PWM Cell X siter
The PWM Cell-X-siter will pulse a square wave pulse to your hydrogen generator. If your cell carries 2 volts between your plates or tubes then you will generate Ortho-Hydrogen ( 2.4x to 4x more powerful than para-hydrogen that stores in a tank!)
PRICE: $100.00
|
|
PWM Monitor & Controller
Analog DC Ammeter inside a black box you install on your dash board. A lighted switch to turn your hydrogen cell on/off. Two control knobs to adjust the amperage and gas production. Comes with cable that goes to your PWM that is mounted near your cell, under your hood. All soldered up and assembled.
PRICE: $250.00
|
|
PWM Monitor & Controller (DIY)
PWM Monitor & Controller (DIY) Do it yourself kit. Analog DC Ammeter inside a black box you install on your dash board. A lighted switch to turn your hydrogen cell on/off. Two control knobs to adjust the amperage and gas production. Comes with cable that goes to your PWM that is mounted near your cell, under your hood. All soldered up and assembled.
PRICE: $120.00
|
|
Safety Bubbler & Spark Arrestor
"Safety Bubbler & Spark Arrestor"
10" tall clear Acrylic Tube, with 2 rubber plumber's caps w/hose clamps & 7 feet of clear PVC hose and nylon elbow.
PRICE: $28.00
|
