|
Electrical Components
|
|
12 Volt RELAY
12 Volt, 30 amp Auto Electric Relay
PRICE: $8.00
|
|
Auto. Water Level Circuit (soldered)
Automatic Water Level Circuit. Ready to Install. All soldered up with 12" wire leads. Works inside your cell with 3 probe wires, or 3 set screws :1)high and 2)low level & 3) ground. Hooks up to 12 volts and to a 12v. water pump tank.
PRICE: $42.00
|
|
Automatic Water Level Circuit
(DIY) U-Solder Automatic Water Level Circuit. Works inside your cell with 3 probes, high and low level & ground. Hooks up to 12 volts and to a 12v. water pump tank.
PRICE: $25.00
|
|
D EFIE
Digital Universal EFIE - MAP/MAF/O2 EFIE - D•EFIE
This circuit is universal, it can be a O2 sensor signal enhancer or EFIE.
It can also be a MAP/or MAF adjuster. Fuel enhancers that allow a lean
burn, if you so desire. Comes with small black plastic box and full down-loadable instructions.
(Click on the circuit to read more about the D•EFIE)
PRICE: $52.00
|
|
DC Ammeter
DC Ammeter, 12 volts, rated 40 amps
PRICE: $18.00
|
|
DIY Dual O2 Sensor U-Solder Kit (EFIE)
The "Do It Yourself" Dual O2 Sensor Fuel Saver Circuit "
This circuit uses one LM324, a Quad Amplifier. This circuit uses 2 amps per O2 sensor, so it will work to adjust two O2 sensors. You can use it for a OBD II car 96 and on. One side adjusts the PRE cat. O2 sensor and the 2nd one adjusts the POST cat. O2 sensor. You can also use just one side of the circuit for a OBD I vechicle 87-95.
PRICE: $35.00
|
|
DIY Dual O2 Sensor WIRE Kit
The designer of the DIY Dual O2 circuit recommends shelided wire, grounded to one side only. It is hard to find single cond. shellded wire. We are selling 22 gauge copper stranded wire and sheilded wire.
PRICE: $12.00
|
|
DIY Dual O2 Sensor pcb board
"Do It Yourself" Dual O2 Sensor Fuel Saver Circuit Board
Easy to solder up, parts list is here.
We also sell this circuit as a U-Solder Kit, comes with all the compontents listed above.
PRICE: $8.00
|
