|
PWM
|
MC-12
|
|
1# PWM Circuit , 40amp (soldered ) in Alum. Box
The 40 amp "Pulsed Width Modifier" DC Circuit. This circuit creates a pulsed DC square wave signal to produce ortho hydrogen. All soldered up, fitted into a aluminum box, with 2 mosfets, tested and ready to install. Guaranteed to work on arrival! *In stock and ready to ship.
PRICE: $140.00
|
|
1# PWM Circuit with Alum. Box Kit
The "Pulsed Width Modifier" DC Circuit. A U-solder it - DIY Kit, with a nice aluminum Box and Heat Sink. This circuit creates a pulsed DC square wave signal to produce ortho hydrogen. Comes with all the MC-12 components, and aluminum box *In stock and ready to ship.
PRICE: $45.00
|
|
1# seller - PWM Circuit
The "Pulsed Width Modifier" DC Circuit. This circuit creates a pulsed DC square wave signal to produce ortho hydrogen.
(A U-Solder Kit.)
PRICE: $28.00
|
|
1# seller - PWM Circuit w/box
The "Pulsed Width Modifier" DC Circuit, with a heat sink bottom plate/box. This circuit creates a pulsed DC square wave signal to produce ortho hydrogen. ( U-Solder Kit)
PRICE: $35.00
|
|
Mosfet & Mounting Hardware
MOSFET, plus mounting hardware, screw, nut, washer & nylon isolation washer, thermal tape backing to heat sink. For the PWM MC-12 circuit.
PRICE: $6.00
|
|
PWM Monitor & Controller
Analog DC Ammeter inside a black box you install on your dash board. A lighted switch to turn your hydrogen cell on/off. Two control knobs to adjust the amperage and gas production. Comes with cable that goes to your PWM that is mounted near your cell, under your hood. All soldered up and assembled.
PRICE: $250.00
|
|
PWM Monitor & Controller (DIY)
PWM Monitor & Controller (DIY) Do it yourself kit. Analog DC Ammeter inside a black box you install on your dash board. A lighted switch to turn your hydrogen cell on/off. Two control knobs to adjust the amperage and gas production. Comes with cable that goes to your PWM that is mounted near your cell, under your hood. All soldered up and assembled.
PRICE: $120.00
|
