|
Pre-Assembled Electronics
|
|
Dual O2 Sensor Circuit & box Soldered (EFIE)
"The Dual O2 Sensor Fuel Saver Circuit " (all soldered up, tested calibrated to one volt & ready to install) Designed by Claudio Cabete aka "Electrojolt" This circuit uses one LM324, a Quad Amplifier. This circuit uses 2 amps per O2 sensor, so it will work to adjust two O2 sensors or one. You can use it for a OBD II car 96 and on. One side adjusts the PRE cat. O2 sensor and the 2nd one adjusts the POST cat. O2 sensor. You can also use just one side of the circuit for a OBD I vechicle 87-95.
PRICE: $85.00
|
|
PWM - 150 amp
A 150 amp max. Pulse Width Modulator, P150 with current limiting capabilities. Excellant choice for a diesel trucker application. Internal fan keeps it running cool.
PRICE: $180.00
|
|
PWM - 25 AMP
PWM - P25 It is a current limiting PWM. It is preset at 12amps but is adjustable up to 25amps. This has an external cooling fan. It is cased in a black ABS plastic box. Comes all soldered up and ready to wire in.
PRICE: $130.00
|
|
PWM - 75 amps
Pulse Width Modulator P75, from Central Valley HHO
75 amps plus current limiting capabilities. Has internal fan to keep it running cool.
PRICE: $150.00
|
|
PWM Cell X siter
The PWM Cell-X-siter will pulse a square wave pulse to your hydrogen generator. If your cell carries 2 volts between your plates or tubes then you will generate Ortho-Hydrogen ( 2.4x to 4x more powerful than para-hydrogen that stores in a tank!)
PRICE: $100.00
|
|
PWM Monitor & Controller
Analog DC Ammeter inside a black box you install on your dash board. A lighted switch to turn your hydrogen cell on/off. Two control knobs to adjust the amperage and gas production. Comes with cable that goes to your PWM that is mounted near your cell, under your hood. All soldered up and assembled.
PRICE: $250.00
|
|
PWM3G1
Pulsed Width Modifier 3 PCB Circuit Board. PWM3_Rev G. All soldered up with the correct components approved by the designer - Bob Boyce. This is designed for the high voltage 101 plate cell.
PRICE: $120.00
|
