|
Air/Fuel Monitoring
|
|
Buddy's Fuel Vaporizer
Buddy's Fuel Vaporizer #4 Gives you up to 25 – 40% Better Mileage. Designed for carbureted gas engines, or fuel injected engines with OBD-I systems (1987 to 1995). OBD-II systems will need a Volo FS2 or EFIE or D-EFIE modifying circuit installed.
PRICE: $149.00
|
|
DC Ammeter
DC Ammeter, 12 volts, rated 40 amps
PRICE: $18.00
|
|
DIY Dual O2 Sensor U-Solder Kit (EFIE)
The "Do It Yourself" Dual O2 Sensor Fuel Saver Circuit "
This circuit uses one LM324, a Quad Amplifier. This circuit uses 2 amps per O2 sensor, so it will work to adjust two O2 sensors. You can use it for a OBD II car 96 and on. One side adjusts the PRE cat. O2 sensor and the 2nd one adjusts the POST cat. O2 sensor. You can also use just one side of the circuit for a OBD I vechicle 87-95.
PRICE: $35.00
|
|
DIY Dual O2 Sensor WIRE Kit
The designer of the DIY Dual O2 circuit recommends shelided wire, grounded to one side only. It is hard to find single cond. shellded wire. We are selling 22 gauge copper stranded wire and sheilded wire.
PRICE: $12.00
|
|
DIY Dual O2 Sensor pcb board
"Do It Yourself" Dual O2 Sensor Fuel Saver Circuit Board
Easy to solder up, parts list is here.
We also sell this circuit as a U-Solder Kit, comes with all the compontents listed above.
PRICE: $8.00
|
|
Digital Multimeter
Cen-Tech Digital Multimeter, 7 function, 19 ranges
PRICE: $10.00
|
|
EFIE 18/1 Fuel Enhancer
The 18/1 Fuel Enhancer (EFIE) A new improved EFIE using modern micro electronics. Designed by a electronic wizard friend. Guaranteed to work as described or your money back. (Comes pre-assembled, no soldering) MADE IN USA
PRICE: $45.00
|
|
PWM3G
Pulsed Width Modifier 3 PCB Circuit Board. PWM3_Rev G. All soldered up with the correct components approved by the designer - Bob Boyce®. This is designed for the high voltage 101 plate cell.
PRICE: $120.00
|
